continuously variable speed grinding and polishing machine

MP-1B continuously variable speed metallographic sample grinding and polishing machine

Product Introduction

The MP-1B new metallographic sample grinding and polishing machine is a single disc machine suitable for pre 

grinding, grinding, and polishing metallographic samples. This machine can directly obtain a speed range of 50-1000 

rpm through frequency converter speed regulation, making it more widely applicable. It is an essential equipment for 

users to make metallographic specimens. This machine is equipped with a cooling device that can cool the sample 

during pre grinding to prevent damage to the metallographic structure due to overheating of the sample. This 

machine is easy to use, safe and reliable, and is an ideal sample preparation equipment for factories, research 

institutions, and laboratories in colleges and universities.

Specification

1. Working voltage: 220V 50HZ

2. Grinding disc diameter: φ 200mm speed 50-1000 rpm

3. Electric motor: YSS7124, 550W

4. Overall dimensions: 650 × three hundred and fifty × three hundred and ten

5. Weight: 30kg

Installation method

Open the outer packaging box of the machine.

Place the machine on a flat and sturdy platform free of debris.

Connect the inlet and outlet pipes at the back of the machine.

Connect the grounding wire properly.

When installing for the first time, use a rubber hammer to knock the grinding plate down axially until it is not loose.

Turn on the power switch and check if the machine is operating properly.

After the inspection is completed, you can proceed with the operation and use.

Contact us

Jinan Fangyuan Testing Machine CO.,Ltd

TEL:13864006141      

Email:jnfysyj01@163.com

Wechat:13864006141

Address:No.276,Nanxinzhuang West Road,Shizhong Dist.,Jinan, Shandong, China. 

Website:www.shijinyiqi.com